Quick Start#

To get started with trinteract, connect an 3.3v arduino pro micro to the board as shown in the picture along with the 3D printed top. If you’re building your own kit head over to the 🛠️ Build Your Own section.

Important

trinteract is only compatible with 3.3 volts, any higher voltage could fry the sensor

../_images/Figure1.png

On Windows, Your computer will recognize trinteract as a game controller. To check if it’s recognized go to: Control Panel → Devices and Printers → Set up USB game controllers and click Properties

../_images/Figure2.png ../_images/Figure3.gif

Note

If trinteract isn’t recognized on your computer you can visit the Troubleshooting guide here